Fittings Do Not Look Right

12 Apr

Revit OpEd: Fittings Do Not Look Right.

When you use the Underlay setting in Revit MEP you run the risk of altering the way your pipe fittings (duct fittings too in views using Detail Level: Coarse) scale and/or look. Here’s a good and bad side by side

The pipes on the left are good but those in the view on the right are smaller and halftone, as a result of using the Underlay setting.

Set to None the fittings look correct, but using the same level the fittings are associated with as the underlay equals sadness. It doesn’t seem to mind if you use other levels as the underlay though. Careful with your underlay!


Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: